LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Back Hinge Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Partially remove the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada)  or Seat Back Cover and Pad Replacement - Rear No. 1 (Trailblazer EXT, Envoy XL) .
  2. Remove the latch release cables (1) from the latch release mechanism, located at the bottom of the seat back frame.
    Fig 1: View Of Latch Release Cables & Head Restraint Release Cable
    GM753531Courtesy of GENERAL MOTORS CORP.
  3. Remove the head restraint release cable (2) from the left hand hinge bracket.
  4. Remove the bolts (2) that retain the latch bracket to the hinge bracket.
    Fig 2: Removing/Installing Latch & Hinge Bracket Mounting Bolts
    GM753533Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolts (1) that retain the hinge bracket to the seat back frame.
  6. Remove the hinge bracket from the seat back frame.
scientia non olet · About LEMON Manuals