LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Back Hinge Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the hinge bracket to the seat back frame.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the hinge bracket to the seat back frame with 2 bolts (1).

    Tighten:  Tighten the seat back hinge bolts to 35 N.m (26 lb ft).

    Fig 1: Removing/Installing Latch & Hinge Bracket Mounting Bolts
    GM753533Courtesy of GENERAL MOTORS CORP.
  3. Install the latch bracket to the hinge bracket with 2 bolts (2).

    Tighten:  Tighten the seat back hinge bolts to 35 N.m (26 lb ft).

  4. Install the latch release cables (1) to the latch release mechanism, located at the bottom of the seat back frame.
    Fig 2: View Of Latch Release Cables & Head Restraint Release Cable
    GM753531Courtesy of GENERAL MOTORS CORP.
  5. Install the head restraint release cable (2) the left hand hinge bracket.
  6. Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada)  or Seat Back Cover and Pad Replacement - Rear No. 1 (Trailblazer EXT, Envoy XL) .
scientia non olet · About LEMON Manuals