Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the seat cushion mounting bolts (1) securing the rear seat cushion frame to the inboard/outboard rear seat back hinge assembly.
Tighten: Tighten all rear seat cushion mounting bolts to 25 N.m (18 lb ft).

Fig 1: Removing/Installing Seat Back Cushion Mounting Bolts
Courtesy of GENERAL MOTORS CORP.
Install the seat back mounting bolts (2) securing the rear seat back frame to the inboard/outboard rear seat back hinge assembly.
Tighten: Tighten all rear seat back mounting bolts to 25 N.m (18 lb ft).
Install the seat belt side buckle (1) to the seat with the seat belt anchor nut (2), if replacing the right-hand seat inboard hinge.
Tighten: Tighten the seat belt side buckle nut to 55 N.m (40 lb ft).

Fig 2: Removing/Installing Side Seat Belt Anchor Nut
Courtesy of GENERAL MOTORS CORP.
Install the rear center seat belt anchor nut (2), if replacing the left-hand seat inboard hinge.
Tighten: Tighten all rear center seat belt anchor nut to 60 N.m (44 lb ft).

Fig 3: View Of Rear Center Seat Belt Anchor Nut
Courtesy of GENERAL MOTORS CORP.
Install the seat back cover and pad to the seat back. Refer toSeat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) or Seat Back Cover and Pad Replacement - Rear No. 1 (Trailblazer EXT, Envoy XL) .
Install the inboard/outboard rear seat back cushion latch covers. Refer to Seat Back Hinge Cover Replacement - Rear No. 1 .
Install the seat in the vehicle. Refer to Seat Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL) .