LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Back Hinge Cover Replacement - Rear No. 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the inboard/outboard rear seat back hinge cover halves around the seat back hinges.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the inboard/outboard rear seat back hinge cover screws.

    Tighten:  Tighten the rear seat back hinge cover screws to 2 N.m (18 lb in).

    Fig 1: Identifying Seat Belt Side Buckle & Retaining Nut
    GM828140Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals