LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Back Frame Replacement - Rear No. 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the two bolts securing the inner riser assembly to the seat back frame.

    Tighten:  Tighten the seat back mounting bolts to 25 N.m (18 lb ft).

    Fig 1: Locating Outer Riser Assembly Mounting Bolts
    GM824165Courtesy of GENERAL MOTORS CORP.
  2. Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 2 .
  3. Install the head restraint assembly. Refer to Head Restraint Replacement - Rear Seat .
scientia non olet · About LEMON Manuals