LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Back Extension Panel Replacement - Rear No. 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the screws (3) securing the seat back extension panel (1) to the seat back.

    Tighten:  Tighten the rear seat back extension panel mounting screws to 10 N.m (88 lb in).

    Fig 1: View Of Extension Panel Hinge Finish Cover & Retaining Screws
    GM824160Courtesy of GENERAL MOTORS CORP.
  2. Install the extension panel hinge finish cover (2).
scientia non olet · About LEMON Manuals