LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Rear No. 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the head restraint assembly. Refer to Head Restraint Replacement - Rear Seat .
  2. Remove the extension panel hinge trim (2).
    Fig 1: Locating Extension Panel Hinge Trim & Retaining Screws
    GM824160Courtesy of GENERAL MOTORS CORP.
  3. Remover the screws (3) securing the extension panel (1) to the seat back.
  4. Remove the J-strip (1) from the seat adjuster cross bar (2).
    Fig 2: Removing/Installing Seat Adjuster Cross Bar J-Strip
    GM824159Courtesy of GENERAL MOTORS CORP.
  5. Unhook the J-strip (1) from the bottom of the seat back cover.
    Fig 3: Removing/Installing J-Strip On Seat Back Cover
    GM824164Courtesy of GENERAL MOTORS CORP.
  6. Remove the hog rings (2) from the seat back cover flaps.
  7. Pull the seat back cover up by releasing the hook and loop fastener strips (2).
    Fig 4: Identifying Hog Rings & Hook And Loop Fasteners
    GM824170Courtesy of GENERAL MOTORS CORP.
  8. Remove the hog rings (1) securing the cover to the pad.
  9. Gently pull the pad away from the seat back frame. It may be glued in places from its original assembly.
    Fig 5: View Of Seat Back Pad On Seat Back Frame
    GM824173Courtesy of GENERAL MOTORS CORP.
  10. Remove the head rest restraint guides by squeezing the tabs on the bottom of the guide together and pulling the guide upward out of the seat.
  11. Remove the cover and pad from the seat back frame.
scientia non olet · About LEMON Manuals