LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Rear No. 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the pad on the seat back frame.
  2. Fit the seat back cover over the top of the seat back frame and pad.
  3. Install the head restraint guides by pushing them through the cover into the frame until the locking tabs snap into place. The guide with the locking tab (1) installs on the right hand side of the seat.
    Fig 1: View Of Head Restraint Guide Locking Tab
    GM752739Courtesy of GENERAL MOTORS CORP.
  4. Install the hog rings (1) to the cover and pad.
    Fig 2: Identifying Hog Rings & Hook And Loop Fasteners
    GM824170Courtesy of GENERAL MOTORS CORP.
  5. Pull the seat back cover down over the pad pressing the hook and loop fastener strips (2) together.
  6. Install the seat back cover flap to the pad with the hog rings (2).
    Fig 3: Removing/Installing J-Strip On Seat Back Cover
    GM824164Courtesy of GENERAL MOTORS CORP.
  7. Install the J-strips (1) across the bottom of the seat back cover.
  8. Install the J-strip (1) to the seat adjuster cross bar (2).
    Fig 4: Removing/Installing Seat Adjuster Cross Bar J-Strip
    GM824159Courtesy of GENERAL MOTORS CORP.
  9. Install the screws (3) securing the extension panel (1) to the seat back.
    Fig 5: Locating Extension Panel Hinge Trim & Retaining Screws
    GM824160Courtesy of GENERAL MOTORS CORP.
  10. Install the extension panel hinge trim (2).
  11. Install the head restraint assembly. Refer to Head Restraint Replacement - Rear Seat .
scientia non olet · About LEMON Manuals