LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Rear No. 1 (Trailblazer EXT, Envoy XL) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat back cover and pad on the seat back frame.
  2. Install the head restraint guides by pushing them through the cover into the frame until the locking tabs snap into place. The guide with the locking tab (1) installs on the right hand side of the seat.
    Fig 1: View Of Retaining Tabs On Head Restraint Guides
    GM752739Courtesy of GENERAL MOTORS CORP.
  3. Install the three hog rings (1) securing the cover to the pad.
    Fig 2: Locating Hook, Loop and Hog Rings On Seat Cover
    GM828143Courtesy of GENERAL MOTORS CORP.
  4. Pull the cover down over the pad ensuring that the hook and loop fasteners (2, 3) are pressed together.
  5. Pull the seat cover back through the opening between the seat cushion and the seat back.
  6. Install the cover side flaps to the frame with the two push pins (1) from each side of the seat back.
    Fig 3: Identifying Seat Back Side Push Pins
    GM828818Courtesy of GENERAL MOTORS CORP.
  7. Install the J-strips (2) on the bottom of the seat back cover (1).
    Fig 4: View Of Bottom Seat Back Cover J Strips
    GM828142Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  8. Install the rear seat belt (1) to the seat with the rear seat belt anchor nut (2).

    Tighten:  Tighten the rear seat belt anchor nut to 55 N.m (41 lb ft).

    Fig 5: View Of Rear Center Seat Belt Anchor Nut
    GM828141Courtesy of GENERAL MOTORS CORP.
  9. Install the inboard rear seat back hinge cover with three screws.

    Tighten:  Tighten the rear seat back hinge cover screws to 2 N.m (18 lb in).

    Fig 6: Identifying Seat Belt Side Buckle & Retaining Nut
    GM828140Courtesy of GENERAL MOTORS CORP.
  10. Install the seat belt bezel to the rear seat back with the plastic retainers (2).
    Fig 7: View Of Bottom Seat Back Cover J Strips
    GM753728Courtesy of GENERAL MOTORS CORP.
  11. Install the head restraint assembly. Refer to Head Restraint Replacement - Rear Seat .
scientia non olet · About LEMON Manuals