LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat back from the vehicle. Refer to Seat Back Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada)  or Seat Back Replacement - Rear No. 1 (TrailBlazer, EXT, Envoy XL) .
  2. Remove the seat belt buckle bracket, on the right side only.
  3. Remove the seat belt anchor bolt from the bracket.
    Fig 1: Locating Seat Belt Anchor Bolt
    GM753723Courtesy of GENERAL MOTORS CORP.
  4. Release the seat belt bezel from the seat back by pressing in the buttons (1) on the plastic retainers.
    Fig 2: Identifying Buttons On Seat Belt Bezel Retainers
    GM753729Courtesy of GENERAL MOTORS CORP.
  5. Remove the seat belt bezel by sliding it off the seat belt.
  6. Remove the head restraints. Refer to Head Restraint Replacement - Rear Seat .
  7. Remove the release latch knob.
    Fig 3: Removing Release Latch Knob
    GM753555Courtesy of GENERAL MOTORS CORP.
  8. Remove the screw that retains the seat back latch release bezel to the seat back.
    Fig 4: Removing/Installing Seat Back Latch Release Bezel Retaining Screw
    GM753553Courtesy of GENERAL MOTORS CORP.
  9. Release the J-strips on the bottom of the seat back frame.
    Fig 5: View Of Bottom Of Seat Back Frame
    GM753560Courtesy of GENERAL MOTORS CORP.
  10. Release the hook and loop retaining strips at the bottom of the seat back.
  11. Remove 3 push-pins from the bottom of the seat back.
    IMPORTANT: Ensure that the hook and loop retaining strips remain attached to the seat back pad.
  12. Release the cover from the hook and loop retaining strips on the front of the seat back pad.
    Fig 6: Identifying Seat Back Pad Cover
    GM753548Courtesy of GENERAL MOTORS CORP.
  13. Remove the 6 push-pins from the seat back.
    Fig 7: Removing/Installing Seat Back Push-Pins
    GM753549Courtesy of GENERAL MOTORS CORP.
  14. Remove the cover and pad from the seat back.
    Fig 8: Removing Seat Cover & Pad
    GM753704Courtesy of GENERAL MOTORS CORP.
  15. Release the 3 hog-rings from the reinforcement bar.
  16. Remove the seat cover from the pad.
scientia non olet · About LEMON Manuals