LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat back pad to the seat back frame.
  2. Install the 6 push-pins that retain the seat back pad to the seat back frame.
    3. Fig 1: Removing/Installing Seat Back Push-Pins
    GM753549Courtesy of GENERAL MOTORS CORP.
  3. Partially install the seat cover.
    Fig 2: Removing Seat Cover & Pad
    GM753704Courtesy of GENERAL MOTORS CORP.
  4. Install the 3 hog-rings to the reinforcement bar.
  5. Install the seat cover the remainder of the way.
    Fig 3: Identifying Seat Back Pad Cover
    GM753548Courtesy of GENERAL MOTORS CORP.
  6. Engage the seat cover to the hook and loop retaining strips on the seat back pad.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  7. Install the screw that retains the rear seat back release latch bezel to the rear seat back.

    Tighten:  Tighten the rear seat back release latch bezel screw to 3 N.m (26 lb in).

    Fig 4: Removing/Installing Seat Back Latch Release Bezel Retaining Screw
    GM753553Courtesy of GENERAL MOTORS CORP.
  8. Install the 3 push-pins at the bottom of the rear seat back.
  9. Engage the hook and loop retaining strips at the bottom of the rear seat back.
  10. Starting at either corner, engage the J-strips at the bottom of the rear seat back.
    Fig 5: View Of Bottom Of Seat Back Frame
    GM753560Courtesy of GENERAL MOTORS CORP.
  11. Install the head restraints. Refer to Head Restraint Replacement - Rear Seat .
  12. Install the seat belt bezel to the rear seat back with the plastic retainers (2).
    Fig 6: Identifying Buttons On Seat Belt Bezel Retainers
    GM753728Courtesy of GENERAL MOTORS CORP.
  13. Install the rear seat belt anchor bolt into the seat belt buckle bracket.

    Tighten:  Tighten the rear seat belt anchor bolt to 55 N.m (41 lb ft).

    Fig 7: Locating Seat Belt Anchor Bolt
    GM753723Courtesy of GENERAL MOTORS CORP.
  14. Install the seat belt buckle bracket, on the right side only.
  15. Install the seat back into the vehicle. Refer to Seat Back Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada)  or Seat Back Replacement - Rear No. 1 (TrailBlazer, EXT, Envoy XL) .
scientia non olet · About LEMON Manuals