LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Adjuster Mechanism Replacement - Manual >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the 4 nuts that secure the seat pan to the power seat adjuster frame.

    Tighten:  Tighten the seat pan mounting nuts to 25 N.m (18 lb ft).

    Fig 1: Removing/Installing Power Seat Adjuster Frame Mounting Nuts
    GM755845Courtesy of GENERAL MOTORS CORP.
  2. Install the seat back. Refer to Seat Back Replacement - Front .
  3. Install the SIR harness to the harness clips (2) on the seat adjuster.
    Fig 2: View Of SIR Wiring Harness Connector & Retaining Clips
    GM755831Courtesy of GENERAL MOTORS CORP.
  4. Install the SIR harness connector (1) to the seat adjuster bracket.
  5. Install the seat belt buckle to the seat adjuster.

    Tighten:  Tighten the seat belt buckle nut to 55 N.m (41 lb ft).

    Fig 3: Removing/Installing Seat Belt Buckle Nut
    GM755837Courtesy of GENERAL MOTORS CORP.
  6. Install the lumbar support cable to the seat adjuster. Refer to Lumbar Support Cable Replacement .
  7. Install the seat cushion trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
  8. Install the front bucket seat assembly to the vehicle. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals