LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Pull Handle Assembly Replacement - Rear No. 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat pull handle (1) on the seat panel.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the two screws (3) to the seat pull handle (1).

    Tighten:  Tighten the rear seat pull handle screws to 4 N.m (36 lb in).

    Fig 1: Identifying Pull Handle & Retaining Screws
    GM824148Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals