LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Outer Riser Assembly Replacement - Rear No. 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat from the vehicle. Refer to Seat Replacement - Rear No. 2 .
  2. Remove the seat latch rod. Refer to Seat Latch Rod Replacement - Rear No. 2 .
  3. Remove the seat riser latch assembly. Refer to Seat Riser Latch Assembly Replacement - Rear No. 2 .
  4. Remove the seat adjuster cross bar. Refer to Seat Adjuster Cross Bar Replacement - Rear No. 2 .
  5. Unhook the J-strip (1) from the bottom of the seat back cover.
    Fig 1: Removing/Installing J-Strip On Seat Back Cover
    GM824164Courtesy of GENERAL MOTORS CORP.
  6. Remove the hog rings (2) from the seat back cover flaps.
  7. Pull the seat cover up to expose the seat back mounting bolts.
  8. Remove the two seat back mounting bolts (1) securing the outer riser assembly to the seat back frame.
    Fig 2: Seat Recliner View
    GM824165Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals