LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Mid-Position Floor Latch Assembly Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat from the vehicle. Refer to Seat Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL) .
  2. Remove the trim panel from the seat cushion. Refer to Seat Cushion Trim Panel Replacement - Rear No.1 (TrailBlazer EXT, Envoy XL) .
  3. Remove the rear center seat belt buckle assembly from the floor latch assembly. Refer to SEAT BELT BUCKLE REPLACEMENT - CENTER REAR (TRAILBLAZER, ENVOY, BRAVADA) or SEAT BELT BUCKLE REPLACEMENT - CENTER REAR (TRAILBLAZER EXT, ENVOY XL) in Seat Belts.
  4. Remove the cable (3) from the mid-position floor latch assembly (2).
    Fig 1: Identifying Mid-Position Floor Latch Assembly Components
    GM828232Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolts (1) securing the mid-position floor latch assembly to the seat cushion frame.
  6. Remove the mid-position floor latch assembly.
scientia non olet · About LEMON Manuals