LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Mid-Position Floor Latch Assembly Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the mid-position floor latch assembly to the seat cushion frame with the bolts (1).

    Tighten:  Tighten the rear seat mid-position floor latch assembly bolts to 35 N.m (26 lb ft).

    Fig 1: Identifying Mid-Position Floor Latch Assembly Components
    GM828232Courtesy of GENERAL MOTORS CORP.
  2. Install the cable (3) to the mid-position floor latch assembly (2).
  3. Install the rear center seat belt buckle assembly to the floor latch assembly. Refer to SEAT BELT BUCKLE REPLACEMENT - CENTER REAR (TRAILBLAZER, ENVOY, BRAVADA) or SEAT BELT BUCKLE REPLACEMENT - CENTER REAR (TRAILBLAZER EXT, ENVOY XL) in Seat Belts.
  4. Install the trim panel to the seat cushion. Refer to Seat Cushion Trim Panel Replacement - Rear No.1 (TrailBlazer EXT, Envoy XL) .
  5. Install the seat in the vehicle. Refer to Seat Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL) .
scientia non olet · About LEMON Manuals