LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Lumbar Replacement - Front Seat >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the lumbar assembly onto the seat.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the lumbar motor mounting screw.

    Tighten:  Tighten the lumbar motor mounting screw to 8 N.m (71 lb in).

    Fig 1: Removing/Installing Lumbar Motor Mounting Screw
    GM753526Courtesy of GENERAL MOTORS CORP.
  3. Attach the lumbar clips onto the top and bottom of the seat back frame.
  4. Connect the electrical connector to the lumbar motor.
  5. Install the seat back panel. Refer to Seat Back Panel Replacement - Front .
  6. Install the seat back pad and cover. Refer to Seat Back Cover and Pad Replacement - Front .
  7. Install the seat in the vehicle. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals