LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Inner Riser Assembly Replacement - Rear No. 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the two rear seat back mounting bolts (1) securing the inner riser assembly to the seat back frame.

    Tighten:  Tighten the rear seat back mounting bolts to 25 N.m (18 lb ft).

    Fig 1: Removing/Installing Inner Riser Assembly Mounting Bolts
    GM824165Courtesy of GENERAL MOTORS CORP.
  2. Pull the seat cover back down over the seat pad.
  3. Secure the seat back cover flaps to the pad with the hog rings (2).
  4. Install the J-strip (1) on the bottom of the seat back cover.
    Fig 2: Removing/Installing J-Strip On Seat Back Cover
    GM824164Courtesy of GENERAL MOTORS CORP.
  5. Install the seat adjuster cross bar. Refer to Seat Adjuster Cross Bar Replacement - Rear No. 2 .
  6. Install the seat riser latch assembly. Refer to Seat Riser Latch Assembly Replacement - Rear No. 2 .
  7. Install the seat latch rod. Refer to Seat Latch Rod Replacement - Rear No. 2 .
  8. Install the seat belt buckle assembly.
  9. Install the seat in the vehicle. Refer to Seat Replacement - Rear No. 2 .
scientia non olet · About LEMON Manuals