LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Head Restraint Retractor Assembly Replacement - Rear No. 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the head restraint retractor assembly to the seat back.
    Fig 1: Aligning Head Restraint Retractor Assembly
    GM753546Courtesy of GENERAL MOTORS CORP.
  2. Install the release cable through the head restraint retractor assembly access hole and sliding the cable retainer into position.
    Fig 2: View Of Release Cable In Head Restraint Retractor Assembly Access Hole
    GM753547Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the 3 bolts that retain the head restraint retractor assembly to the seat back frame.

    Tighten:  Tighten the head restraint retractor bolts to 10 N.m (88 lb in).

    Fig 3: Removing/Installing Head Restraint Retractor Assembly Retaining Bolts
    GM753545Courtesy of GENERAL MOTORS CORP.
  4. Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada)  or Seat Back Cover and Pad Replacement - Rear No. 1 (Trailblazer EXT, Envoy XL) .
scientia non olet · About LEMON Manuals