LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Head Restraint Replacement - Rear Seat >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the retaining clips to the head restraint retractor.
    Fig 1: Removing/Installing Head Restraint Post Retaining Clip
    GM753724Courtesy of GENERAL MOTORS CORP.
  2. Verify that the retaining clips are fully seated.
  3. Install the rear seat head restraint posts to the head restraint retractor, verifying that the notches in the head restraint posts are indexed toward the back of the seat.
    Fig 2: View of Head Restraint Retractor
    GM753741Courtesy of GENERAL MOTORS CORP.
  4. Lower the head restraint to the full down position.