LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Head Restraint Replacement - Front Seat >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the head restraint to the seat assembly.
  2. Verify that the notches in the head restraint posts are indexed toward the rear of the seat assembly.
  3. Push the head restraint downward into the fully installed position.
    Fig 1: Removing/Installing Head Restraint
    GM752736Courtesy of GENERAL MOTORS CORP.
  4. Raise the head restraint to the full up position. Verify that the head restraint retainer prevents the head restraint from being removed from the seat assembly.
scientia non olet · About LEMON Manuals