LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Head Restraint Guide Assembly Replacement - Rear No. 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the head restraint assembly. Refer to Head Restraint Replacement - Rear Seat .
  2. Remove the seat back cover and pad to expose the seat back frame. Refer to Seat Back Cover and Pad Replacement - Rear No. 2 .
  3. Gently pull the pad away from the seat back frame. It may be glued in places from its original assembly.
    Fig 1: Removing/Installing Seat Back Frame Pad
    GM824173Courtesy of GENERAL MOTORS CORP.
  4. Remove the head rest restraint guides by squeezing the tabs on the bottom of the guide together and pulling the guide upward out of the seat.
scientia non olet · About LEMON Manuals