LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Head Restraint Guide Assembly Replacement - Rear No. 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the head restraint guides by pushing them through the cover into the frame until the locking tabs snap into place. The guide with the locking tab (1) installs on the right hand side of the seat.
  2. Install the seat back cover and pad on the seat back frame. Refer to Seat Back Cover and Pad Replacement - Rear No. 2 .
    Fig 1: Removing/Installing Seat Back Frame Pad
    GM824173Courtesy of GENERAL MOTORS CORP.
  3. Install the head restraint assembly. Refer to Head Restraint Replacement - Rear Seat .
scientia non olet · About LEMON Manuals