LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1570 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Trim Plate Replacement - Instrument Panel (I/P) Accessory Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the headlamp trim plate to the IP, ensuring the retaining clips are fully seated.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the 2 headlamp trim plate retaining screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

    Fig 1: Removing/Installing Headlamp Trim Plate & Retaining Nuts
    GM712835Courtesy of GENERAL MOTORS CORP.
  3. Install the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
  4. Install the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left .
scientia non olet · About LEMON Manuals