LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1570 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Trim Panel Replacement - Knee Bolster >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the trim panel to the IP.
  2. Seat the clips that retain the trim panel to the IP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the 4 trim panel retaining screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

    Fig 1: Locating Knee Bolster Trim Panel & Screws
    GM712827Courtesy of GENERAL MOTORS CORP.
  4. Install the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left .
scientia non olet · About LEMON Manuals