LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1570 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Instrument Panel Cluster (IPC) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the IPC to the IP.
  2. Connect the electrical connector to the IPC.
  3. Install the IPC to the IP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the screws to the instrument panel cluster.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

    Fig 1: Removing/Installing Instrument Panel Cluster (IPC) & Retaining Screws
    GM692029Courtesy of GENERAL MOTORS CORP.
  5. Install the instrument panel (IP) accessory trim plate, GMC or Oldsmobile only. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory (Chevrolet)  or Trim Plate Replacement - Instrument Panel (I/P) Accessory (Oldsmobile) .
  6. Install the instrument panel cluster (IPC) bezel, Chevrolet only. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster (Chevrolet)  or Bezel Replacement - Instrument Panel (I/P) Cluster (GMC/Oldsmobile) .
  7. Install the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
  8. Install the left closeout insulator panel. Refer to Closeout/Insulator Panel Replacement - Left .
  9. If installing a new IPC. Refer to Instrument Panel Cluster (IPC) Programming/Synchronization .
scientia non olet · About LEMON Manuals