LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1570 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Closeout/Insulator Panel Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the insulator panel to the vehicle, positioning the insulator panel to the IP.
    Fig 1: Removing/Installing Closeout/Insulator Panel Retaining Screws
    GM712812Courtesy of GENERAL MOTORS CORP.
  2. Install the electrical connector retaining clip to the back side of the insulator panel if equipped.
  3. Insert the insulator panel retaining tab into the cowl slot.
  4. Seat the insulator panel retaining clip to the IP substrate.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the 2 insulator panel retaining screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

scientia non olet · About LEMON Manuals