LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1570 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Closeout/Insulator Panel Replacement - Instrument Panel (I/P) Lower (GMC/Chevrolet) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the closeout panel to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the 4 screws that retain the closeout panel to the IP.

    Tighten:  Tighten the screws to 1.9 N.m (17 lb in).

    Fig 1: Removing/Installing Closeout Panel & Retaining Screws
    GM718760Courtesy of GENERAL MOTORS CORP.
  3. Install the floor console. Refer to Console Replacement 
scientia non olet · About LEMON Manuals