LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1570 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Cigar Lighter Housing or 12 Volt Accessory Power Receptacle Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 12-volt power supply or cigar lighter fuse.
  2. Remove the socket by placing one side of the "T" portion of the tool J 42059  into the socket and into the square window tab. See Special Tools and Equipment .
    Fig 1: Removing Cigar Lighter Socket With J 42059
    GM741508Courtesy of GENERAL MOTORS CORP.
  3. Position the opposite "T" portion of the tool into the opposing square window tab.
  4. Pull the socket straight out of the retaining ring.
    Fig 2: Removing/Installing Socket Out Of Retaining Ring
    GM741509Courtesy of GENERAL MOTORS CORP.
  5. Remove the tool from the socket.
  6. Disconnect the electrical connector from the socket.
    Fig 3: Disconnecting/Connecting Socket Electrical Connector
    GM741510Courtesy of GENERAL MOTORS CORP.
  7. Using your finger, remove the socket retaining ring by pulling the retaining ring out of the mounting hole.
    Fig 4: Removing/Installing Socket Retaining Ring
    GM741511Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals