LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1570 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Bracket Replacement - Console Floor >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Block the wheels to prevent the vehicle from moving.
  2. Remove the floor shift control knob. Refer to FLOOR SHIFT KNOB .
  3. Remove the center console. Console Replacement 
  4. Disconnect the automatic transmission range selector cable. Refer to FLOOR SHIFT CONTROL CABLE .
  5. Disconnect the electrical connector from the automatic transmission shift interlock solenoid.
  6. Disconnect the electrical connector from the park brake.
  7. Remove the console bracket from the vehicle, by removing the retaining nuts (1) from the center instrument panel (IP) bracket.
    Fig 1: Identifying Console Floor Bracket
    GM741605Courtesy of GENERAL MOTORS CORP.
  8. Remove the forward retaining screw, if equipped.
  9. Remove the remaining fasteners from the console bracket.
  10. Remove the console bracket from the vehicle.
  11. Remove the floor shift control. Refer to FLOOR SHIFT CONTROL ASSEMBLY .
scientia non olet · About LEMON Manuals