LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1570 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Bezel Replacement - Instrument Panel (I/P) Cluster (Chevrolet) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Tilt the steering wheel to the full down position.
  2. Remove the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left .
  3. Remove the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
  4. Remove the screws retaining the bezel to the instrument panel.
    Fig 1: View Of Instrument Panel (I/P) Cluster Bezel & Retaining Screws
    GM712814Courtesy of GENERAL MOTORS CORP.
  5. Remove the bezel from the instrument panel.
  6. If equipped, remove the transfer case shift control switch. Refer to TRANSFER CASE SHIFT CONTROL SWITCH REPLACEMENT (GMC, BUICK) or TRANSFER CASE SHIFT CONTROL SWITCH REPLACEMENT (CHEVROLET) in Transfer Case.
  7. Remove the rear wiper washer switch. Refer to WIPER/WASHER SWITCH REPLACEMENT - REAR in Wipers Washer Systems.
  8. If equipped, remove the cigar lighter or 12-volt power supply outlets. Refer to Cigar Lighter Housing or 12 Volt Accessory Power Receptacle Replacement .
  9. Remove the bezel from the vehicle.
scientia non olet · About LEMON Manuals