LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1570 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Bezel Replacement - Instrument Panel (I/P) Cluster (Chevrolet) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped, install the cigar lighter or 12-volt power supply outlets. Refer to Cigar Lighter Housing or 12 Volt Accessory Power Receptacle Replacement .
  2. Install the rear wiper washer switch. Refer to WIPER/WASHER SWITCH REPLACEMENT - REAR in Wipers Washer Systems.
  3. If equipped, install the transfer case shift control switch. Refer to TRANSFER CASE SHIFT CONTROL SWITCH REPLACEMENT (GMC, BUICK) or TRANSFER CASE SHIFT CONTROL SWITCH REPLACEMENT (CHEVROLET) in Transfer Case.
  4. Install the bezel to the instrument panel.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the screws retaining the bezel to the instrument panel.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

    Fig 1: View Of Instrument Panel (I/P) Cluster Bezel & Retaining Screws
    GM712814Courtesy of GENERAL MOTORS CORP.
  6. Install the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
  7. Install the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left .
scientia non olet · About LEMON Manuals