LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1566 (Engine Mechanical (Repair Instructions 2 Of 3) - 5.7L) >> Off-Vehicle Repair Instructions - Part 2 >> Camshaft Removal

Camshaft Removal

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Camshaft Position (CMP) Sensor & Bolt
    GM260128Courtesy of GENERAL MOTORS CORP.
  1. Remove the camshaft position (CMP) sensor bolt and the sensor.
    2. Fig 2: View Of Camshaft Retainer Plate
    GM63211Courtesy of GENERAL MOTORS CORP.
  2. Remove the camshaft retainer bolts and the retainer.
    3. Fig 3: View Of Bolts installed In Camshaft Front Bolt Holes
    GM63212Courtesy of GENERAL MOTORS CORP.
    NOTE: All camshaft journals are the same diameter, so care must be used in removing or installing the camshaft to avoid damage to the camshaft bearings.
  3. Remove the camshaft.
    1. Install the 3 M8 - 1.25 x 100 mm bolts in the camshaft front bolt holes.
    2. Using the bolts as a handle, carefully rotate and pull the camshaft out of the engine block.
    3. Remove the bolts from the front of the camshaft.
scientia non olet · About LEMON Manuals