LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1562 (Rear Drive Axle) >> Repair Instructions >> Output Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Axle Seal Into Differential Using J 46405
    GM180886Courtesy of GENERAL MOTORS CORP.
  1. Using the J 46405  , install the differential output shaft seal. See Special Tools and Equipment .
  2. Install the drive shaft. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
  3. Install the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals