LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1560 (Propeller Shaft) >> Repair Instructions >> Driveline Tunnel Closeout Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Bolt To Closeout Panel Slotted Hole
    GM71468Courtesy of GENERAL MOTORS CORP.
  1. Install the driveline tunnel closeout panel into position.
  2. Install the bolt into the closeout panel locating hole (1).
  3. Install the bolt into the closeout panel slotted hole (2)
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: ALL of the driveline tunnel closeout panel bolts must be installed and torqued to specifications, the closeout panel functions as a part of the vehicle body structure.
  4. Install the remaining bolts.

    Tighten:  Tighten the driveline tunnel closeout panel bolts to 10 N.m (89 lb in).

  5. Install the catalytic converters. Refer to Catalytic Converter Replacement in Engine Exhaust.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals