LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1560 (Propeller Shaft) >> Repair Instructions >> Driveline Support Overhaul >> Rear Bearing Housing Disassembly - Manual Transmission

Rear Bearing Housing Disassembly - Manual Transmission

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Bearing Housing Assembly & Snap Ring To Hub
    GM499266Courtesy of GENERAL MOTORS CORP.
  1. Position the rear bearing housing assembly into a press. Apply pressure to the housing and compress the wave washer in order to remove the snap ring (1) from the hub.
    2. Fig 2: Snap Ring To Hub
    GM499224Courtesy of GENERAL MOTORS CORP.
  2. Remove the snap ring (1) from the hub.
    3. Fig 3: Bearing Housing Assembly At Hub With Bearing To Housing
    GM499252Courtesy of GENERAL MOTORS CORP.
  3. Position the bearing housing assembly (1) into a press in order to remove the hub and bearing assembly (2).
  4. Remove the hub, with bearing (1) from the housing. The wave washer will remain in the housing.
    5. Fig 4: Snap Rings & Bearing To Hub
    GM499254Courtesy of GENERAL MOTORS CORP.
  5. Remove the snap rings (1) and bearing (2) from the hub (3).
    6. Fig 5: Propeller Shaft Bushing & Transmission Input Shaft Bushing To Hub
    GM499258Courtesy of GENERAL MOTORS CORP.
  6. Remove the propeller shaft bushing (1) and transmission input shaft bushing (2) from the hub (3) - manual transmission.
    7. Fig 6: Snap Ring To Rear Bearing Housing
    GM499255Courtesy of GENERAL MOTORS CORP.
  7. Remove the snap ring (1) from the rear bearing housing.
    8. Fig 7: Rear Bearing Housing To Press & Remove Bearing
    GM499257Courtesy of GENERAL MOTORS CORP.
  8. Position the rear bearing housing into a press and remove the bearing (1).
    9. Fig 8: O-Rings To Rear Bearing Housing
    GM499251Courtesy of GENERAL MOTORS CORP.
  9. Remove the O-rings (1) from the rear bearing housing.
  10. Discard the O-rings.
    11. Fig 9: Wave Washer To Rear Bearing Housing
    GM499263Courtesy of GENERAL MOTORS CORP.
  11. Remove the wave washer (1) from the rear bearing housing.
scientia non olet · About LEMON Manuals