Rear Camber Adjustment
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen the lower control arm cam bolt nuts.
- Rotate the cam bolts to the required camber specification setting. Refer to Wheel Alignment Specifications .
- Maintain the camber setting while tightening the cam bolt nuts.
Tighten:
- Tighten the rear lower control arm (front) bolt nut to 145 N.m (107 lb ft).
- Tighten the rear lower control arm (rear) bolt nut to 95 N.m (70 lb ft).
- Check the camber setting after tightening.
Adjust the camber setting if necessary.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
IMPORTANT:
Check the toe setting AFTER changing camber or caster.