LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1557 (Front Suspension System) >> Repair Instructions >> Shock Absorber Replacement (W/F55) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the J 43822  to the shock absorber. See Special Tools and Equipment .
  2. Install the insulator and insulator retainer to the shock absorber.
    3. Fig 1: Front Shock ESC Harness Connector
    GM906230Courtesy of GENERAL MOTORS CORP.
  3. Position the shock absorber between the upper shock support and lower control arm.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the insulator, insulator retainer and nut to the upper shock shaft.

    Tighten:  Tighten the nut to 26 N.m (19 lb ft).

  5. Remove the J 43822  from the shock absorber. See Special Tools and Equipment .
  6. Using the J 33432-A  , compress the coil spring. See Special Tools and Equipment .
  7. Raise the lower control arm to the shock absorber lower mounting and install the bolts and nuts.

    Tighten:  Tighten the nut to 28 N.m (21 lb ft).

  8. Remove the J 33432-A  from the coil spring. See Special Tools and Equipment .
  9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  10. Lower the vehicle.
    11. Fig 2: Shock Absorber Lower Mounting Bolts & Nuts
    GM906229Courtesy of GENERAL MOTORS CORP.
  11. Connect the ESC harness connector. Check the connection by lightly pulling upwards on the connector.
scientia non olet · About LEMON Manuals