Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Exhaust System Inspection Notice in Cautions and Notices.

Fig 1: Hanger Muffler Blade

Courtesy of GENERAL MOTORS CORP.

Install the left muffler.
Slide the muffler blade into the hanger.

Fig 2: Exhaust Muffler, Bolts & Gaskets

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install a NEW exhaust muffler gasket.
Install the left side exhaust muffler bolts.
Tighten: Tighten the exhaust muffler bolts to 50 N.m (37 lb ft).

Fig 3: Rear Stabilizer Shaft Brackets, Bolts & Insulators

Courtesy of GENERAL MOTORS CORP.

Position the rear stabilizer shaft upwards.
Install the rear stabilizer shaft insulators and brackets.
Install the rear stabilizer shaft bracket bolts and nuts.
Tighten:
- Tighten the rear stabilizer shaft bracket bolts to 65 N.m (49 lb ft).
- Tighten the rear stabilizer shaft bracket nuts to 95 N.m (70 lb ft).