LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1555 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement (W/O F55) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Shock Absorber & Lower Mounting Bolt
    GM65329Courtesy of GENERAL MOTORS CORP.
  1. Install the upper insulator and insulator retainer to the shock absorber.
  2. Install the shock absorber to the shock tower and to the lower control arm.
  3. Install the tie rod from the control arm. Refer to Rack and Pinion Outer Tie Rod End Replacement .
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the upper shock absorber mounting bolts.

    Tighten:  Tighten the upper mounting bolts to 30 N.m (22 lb ft).

    5. NOTE: To avoid breaking the mounting bolt that attaches the shock absorber to the lower control arm, tighten the bolt. Do NOT tighten the nut.
  5. Install the lower shock absorber mounting bolt.

    Tighten:  Tighten the shock absorber lower mounting nut to 145 N.m (107 lb ft).

    6. Fig 2: Shock Absorber ESC Harness Connector
    GM581266Courtesy of GENERAL MOTORS CORP.
  6. Connect the shock absorber ESC electrical connector, if equipped.
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals