LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1555 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement (W/F55) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and Support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
    3. Fig 1: Rear Shock ESC Harness Connector & Harness Pigtail
    GM906237Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the rear shock electronic suspension control (ESC) harness connector.
  4. Disconnect the harness pigtail from the upper shock tower clip.
    5. Fig 2: Upper Shock Absorber & Mounting Bolts
    GM906234Courtesy of GENERAL MOTORS CORP.
  5. Remove the lower shock absorber to lower control arm retaining bolt.
  6. Remove the upper shock absorber mounting bolts.
  7. Disconnect the outer tie rod from the suspension knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement in Power Steering System.
  8. Carefully remove the shock absorber from the vehicle. Take care when routing the ESC pigtail and connector through the upper shock tower.
  9. Remove the upper insulator retainer and insulator from the shock absorber.
scientia non olet · About LEMON Manuals