LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1552 (Power Steering System) >> Repair Instructions >> Tie Rod Replacement - Inner - On Vehicle >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Inner Tie Rod, Shock Dampener & Rack Assembly
    GM470310Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Support the vehicle with suitable safety stands.
  2. Remove the tire and wheel assembly from the vehicle. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the rack and pinion boot. Refer to Rack and Pinion Boot Replacement - On Vehicle .
    NOTE: Do not change the rack bearing preload adjustment before removing the inner tie rod from the steering rack. This could cause damage to the pinion or the steering rack or both.
  4. Remove the shock dampener (2) from the inner tie rod (5).
  5. Slide the shock dampener (2) back onto the rack (1).
    IMPORTANT: Do not hold the steering rack while removing the inner tie rod if the preload adjustment has not been changed.
  6. Remove the inner tie rod (5) from the rack assembly (1) as follows:
    • Place a wrench on the flats of the inner tie rod housing (4)
    • Rotate the inner tie rod housing (4) counterclockwise until the inner tie rod (5) separates from the rack.
    7. Fig 2: Rack, Inner Tie Rod & Threads
    GM297389Courtesy of GENERAL MOTORS CORP.
  7. Remove the old Loctite® from the threads (2) of the rack (1) and the inner tie rod (3).
scientia non olet · About LEMON Manuals