Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Outer Tie Rod End Stud, Inner Tie Rod, Steering Knuckle & Jam Nut

Courtesy of GENERAL MOTORS CORP.

Install the outer tie rod end (5) to the inner tie rod assembly (1). Do not tighten the jam nut.
Install the outer tie rod end stud (5) to the steering knuckle (4).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the outer tie rod end stud nut (3) to the outer tie rod end stud (5).
Tighten:
1. Tighten the outer tie rod end stud nut to 20 N.m (15 lb ft) to seat the stud.
2. Turn the nut an additional 160 degrees.
3. Check for the outer tie rod end stud nut for a minimum final torque of 45 N.m (33 lb ft).

Fig 2: Wheel Toe, Rack & Pinion Boot

Courtesy of GENERAL MOTORS CORP.

Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.

IMPORTANT: Do not twist the rack and pinion boot during toe adjustment.

Adjust the wheel toe. Refer to Front Toe Adjustment in Wheel Alignment.