LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1550 (Parking Brake System) >> Repair Instructions >> Park Brake Warning Lamp Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disengage Retainer Clips On Park Brake Lever Boot
    GM63996Courtesy of GENERAL MOTORS CORP.
  1. Remove the console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
  2. Remove the passenger seat. Refer to Seat Replacement (Power) or Seat Replacement (Manual) in Seats.
  3. Lift and disengage retainer clips on park brake lever boot.
    4. Fig 2: Parking Brake Lever Assembly Mounting Bolts
    GM63998Courtesy of GENERAL MOTORS CORP.
  4. Lift the park brake lever slightly until it engages the first stop.
  5. Remove the park brake lever assembly mounting bolts.
  6. Disconnect the electrical connector from the park brake switch.
  7. Position the park brake lever assembly to the rear of the vehicle.
  8. Remove the park brake switch.
scientia non olet · About LEMON Manuals