LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1550 (Parking Brake System) >> Repair Instructions >> Park Brake Warning Lamp Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Parking Brake Lever Assembly Mounting Bolts
    GM63998Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake switch to the park brake lever assembly.
  2. Position the park brake lever assembly to the driveline tunnel.
  3. Connect the electrical connector to the park brake switch.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the mounting bolts to the park brake lever assembly.

    Tighten:  Tighten the park brake lever assembly mounting bolts to 28 N.m (21 lb ft)

    5. Fig 2: Disengage Retainer Clips On Park Brake Lever Boot
    GM63996Courtesy of GENERAL MOTORS CORP.
  5. Position the park brake lever assembly boot to the driveline tunnel.
  6. Install the park brake lever assembly boot nuts.

    Tighten:  Tighten the park brake lever assembly boot nuts to 10 N.m (89 lb in)

  7. Install the passenger seat. Refer to Seat Replacement (Power) or Seat Replacement (Manual) in Seats.
  8. Install the console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
  9. Release the park brake lever.
scientia non olet · About LEMON Manuals