LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1550 (Parking Brake System) >> Repair Instructions >> Park Brake Lever Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Parking Brake Cable To Drive Sector & Park Brake Lever Assembly
    GM404107Courtesy of GENERAL MOTORS CORP.
  1. Connect the front parking brake cable to the drive sector and park brake lever assembly.
    2. Fig 2: Parking Brake Lever Assembly Mounting Bolts
    GM63998Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the parking brake lever assembly mounting bolts.

    Tighten:  Tighten the parking brake lever assembly mounting bolts to 28 N.m (21 lb ft).

    3. Fig 3: Parking Brake Electrical Connector
    GM63992Courtesy of GENERAL MOTORS CORP.
  3. Connect the parking brake electrical connector.
  4. Enable the parking brake automatic adjuster. Refer to Enabling the Park Brake Cable Automatic Adjuster .
    5. Fig 4: Disengage Retainer Clips On Park Brake Lever Boot
    GM63996Courtesy of GENERAL MOTORS CORP.
  5. Install the parking brake lever boot nuts.

    Tighten:  Tighten the parking brake lever boot nuts to 10 N.m (89 lb in).

  6. Install the passenger seat. Refer to Seat Replacement (Power) or Seat Replacement (Manual) in Seats.
  7. Install the accessory trim plate. Refer to Console Replacement in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals