LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1550 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Pass-Through Grommet & Front Bracket To Cable
    GM63997Courtesy of GENERAL MOTORS CORP.
  1. Install the front bracket and pass-through grommet to the cable.
  2. Install the front park brake cable to the vehicle. Insure the pass-through grommet is properly installed.
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Install the front park brake cable bracket to the tunnel.
    5. Fig 2: Front & Rear Park Brake Cables To Equalizer & Retainer
    GM99268Courtesy of GENERAL MOTORS CORP.
  5. Connect the front park brake cable to the park brake cable retainer.
  6. Connect the rear park brake cables to the equalizer.
  7. Install the RH muffler. Refer to Muffler Replacement - Right in Engine Exhaust.
  8. Lower the vehicle.
  9. Install the park brake lever. Refer to Park Brake Lever Assembly Replacement .
scientia non olet · About LEMON Manuals