LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1550 (Parking Brake System) >> Repair Instructions >> Park Brake Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Caliper Bolt Shaft
    GM64006Courtesy of GENERAL MOTORS CORP.
  1. Apply high temperature, silicone lubricant to positions 1 and 2. Do not apply grease to the bolt threads (3).
  2. Install the actuator to the dust shield.
  3. Apply high temperature, silicone lubricant to the brake caliper bolt shaft. Do not lubricate the bolt threads.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the actuator mounting bolts.

    Tighten:  Tighten the actuator mounting bolts to 70 N.m (52 lb ft)

    5. Fig 2: View Of Park Brake Shoe Assembly
    GM64007Courtesy of GENERAL MOTORS CORP.
  5. Install the park brake shoe assembly by grasping the shoe and spreading slightly while pulling the shoe over the actuator assembly.
    6. Fig 3: View Of Park Brake Shoes
    GM64008Courtesy of GENERAL MOTORS CORP.
  6. Install the park brake shoe retaining spring.
  7. Adjust the park brake. Refer to Park Brake Adjustment .
  8. Install the brake rotor. Refer to Brake Rotor Replacement - Rear in Disc Brakes.
scientia non olet · About LEMON Manuals