Disc Brake Mounting and Hardware Inspection - Front
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Refer to Brake Dust Caution
in Cautions and Notices.
- Inspect the disc brake pad mounting hardware for the following:
- Missing mounting hardware.
- Excessive corrosion.
- Bent mounting tabs.
- Looseness at the caliper mounting bracket.
- Looseness at the disc brake pads.
- If any of the conditions listed are found, the disc brake pad mounting hardware requires replacement.
- Ensure the disc brake pads are held firmly in place on the caliper mounting bracket, yet slide easily on the mounting hardware without binding.
- Inspect the caliper slide pins (3) by gently pulling outward, without disengaging the slides from the boots, then pushing inward, and observe for the following:
- Binding
- Seizing
- Looseness
- Bent or damaged slide pins
- Cracked or torn slide pin boots (2)
- Missing slide pin boots
- Bent or damaged caliper mounting bracket
- If any of the conditions listed are found, the caliper mounting hardware requires replacement.