LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1546 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Recirculation Door Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the recirculation door into the recirculation housing.
  2. Install the recirculation actuator.
    3. Fig 1: Recirculation Actuator Vacuum Hose
    GM295315Courtesy of GENERAL MOTORS CORP.
  3. Install the recirculation housing to the HVAC module.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the recirculation housing screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  5. Connect the recirculation actuator vacuum hose.
  6. Install the SIR bracket. Refer to Bracket Replacement - SIR in Instrument Panel, Gages and Console.
  7. Install the I/P trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals